Preused, Quality Stretchblow Molding Machines maintained at high efficiency levels.
For the production for bi-orientated PET bottles
SIDEL Blowmolding Machine, model SBO20 series 2, manufactured in 2002
Currently in operation: 20 blowstations x 1.500 =30.000 bph), set up to run process preforms with PCO1881-neck finishes.
SIG Corpoplast Blowmolding Machine, model BLOMAX16 IIIC, manufactured in 2005
Currently in operation at approx.28.000 bph, set up to run preforms with PCO1881-neck finish.
Blowair recovery by AIRBACKplus (KHS-Corpoplast ®) – retrofitted in 2015 to reduce blowair requirement, save energy and downsize high-pressure compressor.
SIDEL Blowmolding Machine, model SBO8 series 2, manufactured in 2001
Nominal output = 12.000 bph
Four (4) sets of blow molds
for four bottle formats/sizes
Semi-automatic Large Container stretchblow molding system
model PETCon10 – set up at GloCon for demonstration, manufactured in 2007:
the manufacture of large bottles with volumes of up to 12 litres.
Complete, including chiller, one blowair compressor with air dryer and one 10-l-mold
preform for 10-l-bottle,
10-l-bottle (drawing, blown sample)
closure and handle outside sourcing
Complete semi-automatic large container stretchblow system
with chiller, compressor, receiver, airdryer, filters (has been used for training + demonstration only).
Above from left2right: air dryer for high-pressure blow compressor,. compressor with accumulator receiver tank.
TetraPak Blowmolding Machine, model L X-6, manufactured in 2000
Currently set up for demonstration at GloCon:
L X-6 with preform tipper + infeed.
Enhanced heating by IR-camera-controlled high power single filament lamps in 6-lanes → precise temperature profiling.
servo-stretching technology for adjusting the stretch system to differing preform/bottle specifications on the touchscreen HMI.
Technical & economical Support
Conversions to alternative neck geometries are possible (optional).
Bottle/ preform design assistance.
e.g., „bottle family“designs
Capacity matching chillers, pumps, dehumidifyers, etc. on enquiry
For Sale Now: Active laboratory for sample blowing and testing preforms and bottles
Partial view of test room
Single Cavity Blow Station (max.application: Ø 110/H 360 mm) - Lab blower control
Single cavity blow station
Lab blower control panel
ZERMA-Recycling Mill (100-200 bottles/hour; depending on bottle weight and size)
Poralized Light Preform Checker
Burst Pressure Tester for CO₂ (CSD) bottles
set of adapters and tools for single cavity test blower
Bottle segment cutter
left: Topload tester, right: Height measuring device
PET Resin Dryer, model DR104HT
Manufactured by PLASTIC SYSTEMS in 2007, complete with 1.200-l-silo, pump etc. - for 250 kg/hour